@thesis{thesis,
		author={Mangapul  Juara and Pratama  Pungki Tri Abdi},
		title ={PENGARUH PENGASUTAN MOTOR TERHADAP KEDIP
TEGANGAN DI PERALATAN LISTRIK INDUSTRI},
		year={2018},
		url={http://156.67.221.169/1942/},
		abstract={An electric power system must have a high system that makes it possible to provide electricity that is needed continuously and with good power quality in terms of frequency regulation and regulation. One of the most common problems in electric power systems is voltage sags. This level of blink can be accessed by large load loads or large capacity motorcycles. In starting the motor the start current produced can reach 5-10 times the nominal value, it is necessary to do the starting motor method to reduce this large current. This research was conducted at PT. KMI Wire and Cable. Simulation of motorization in the electrical network is carried out using the method that is the motor asut before using the star-delta method with the measurement of the voltage blink obtained at 74,8%, when the motor rotates normally the measurement results blink of voltage is 14.9%, and when using the star-delta method with a blinking result that yields 4.99%. The results of these measurements are then compared with existing standards. By looking at the standards and results of the analysis, the motorization of the motor using the star-delta method is much smaller than before using the star ?delta method}
		}