PERANCANGAN MESIN POWER PACK HIDROLIK PADA
PT. INDONESIA POWER SUB UNIT PLUMBUNGAN
Total View This Week0
Total View This Week0
Institusion
INSTITUT TEKNOLOGI DIRGANTARA ADISUTJIPTO
Author
KUNCORO, SADAM
Subject
T Technology (General)
Datestamp
2024-06-26 06:02:33
Abstract :
The design of a hydraulic power pack engine is carried out for the process of opening and closing the turbine valve that is in accordance with the operational requirements of the turbine. Therefore, researchers have the idea of designing a hydraulic engine that fits to those conditions. During the planning process, analysis was done based on the workload of the turbine valve, then the force needed for the process of opening and closing the turbine valve were obtained. The magnitude of the force for opening and closing the turbine valve at this flow was 325,24 N. In order to obtain this force, several other supporting variables are needed with the following specification: motor power 35 KW, tank volume 0.12 m3, pump pressure 44.4 Bar with a pump capacity was 37.5 liter/minutes and the size of the inlet pipe having an outer diameter was 42.00 mm, the inner diameter was 36.2 mm and the pipe thickness was 3,0 mm. The inner diameter for the pressure duck pipe was 14.5 mm, the outer diameter was 28 mm and the pipe thickness was 1.5 mm. Meanwhile, the return pipe had an inner diameter for 22.8 mm, the outer diameter was 16 mm and the thickness was 3 mm
The design of a hydraulic power pack engine is carried out for the process of opening and closing the turbine valve that is in accordance with the operational requirements of the turbine. Therefore, researchers have the idea of designing a hydraulic engine that fits to those conditions. During the planning process, analysis was done based on the workload of the turbine valve, then the force needed for the process of opening and closing the turbine valve were obtained. The magnitude of the force for opening and closing the turbine valve at this flow was 325,24 N. In order to obtain this force, several other supporting variables are needed with the following specification: motor power 35 KW, tank volume 0.12 m3, pump pressure 44.4 Bar with a pump capacity was 37.5 liter/minutes and the size of the inlet pipe having an outer diameter was 42.00 mm, the inner diameter was 36.2 mm and the pipe thickness was 3,0 mm. The inner diameter for the pressure duck pipe was 14.5 mm, the outer diameter was 28 mm and the pipe thickness was 1.5 mm. Meanwhile, the return pipe had an inner diameter for 22.8 mm, the outer diameter was 16 mm and the thickness was 3 mm
Download
book
BibTex
Latex, Jabref
cloud_download
Original Resource
url resource Institution
